Locate the wiring harness behind the fuel pump.
The barometric pressure sensor has a rubber protective flap over top.
Pull back the flap to expose the sensor.
Cut the tape and the zip ties/cable ties or just leave if you would
like.
Slide the tab lock to the left to unlock.
Back by the wire connection, squeeze the back second locking machoism
and remove the sensor.
Plug the Ugly Fix™ back into the wire harness.
Take the zip ties/cable ties and secure it back to the main wire
harness.
On RV installations you will have to come up from underneath the right
side of engine in the front.
Your Done
Note: Sometimes the old sensor can be difficult to remove for the fact
it has been there for a while so be patient.
Now when the key is turned on the EGR will go to the closed position and
stay there.
